Welcome to Dak FPV!
5" ARM FOR THE REVERB FPV FRAME
Weight = 12.0g per arm 4mm carbon arms
Price is Per Arm.
3oz Copper - 1.6mm PCB
Genuine XT-60 with 14AWG Silicon wire
7 Pin JST-GH to solid core Silicon wire (For generic setup)
7 Pin JST-GH to 6 Pin JST-SH x2 (For KISS FC)
Adhesive strip for PDB
Side plates for the Chameleon with a hole pattern that should match the newer Runcam and Foxeer 3-hole camera cases. The Runcam case still might be a little tight, since it is 0.5mm wider than the Foxeer cases, but you should be able to squeeze it enough to fit. Allows for 15-75deg tilt.
This is the 5 inch Chameleon main plate
Replacement Lipo Top Plate for Chameleon
Rubber Motor Dampeners, Smooths out motor vibes.
These are replacement bolts for the Chameleon frame.
2x M3 8mm cup head iron bolts
2x M3 8mm countersunk iron bolts
4x M3 10mm iron bolts
12x M2 5mm cup head iron bolts
4x M2 12mm cup head iron bolts
Replacement Camera protector for Chameleon
Armattan Connector Saver
Wrap it or you'll snap it.
Are you are tired of dangling pigtails endangering your props? Are you tired of risking damage to your PDB or battery connector in the event a LiPo ejection in a (spectacular) crash? Try out the Connector Saver to protect you and yours. This clever accessory will allow your c...
Chameleon Camera Hardware Set
2x rubber dimes
2x alumi thumb screws
2x M2 5mm bolt
2x M2 washer