Welcome to Dak FPV!
Side plates for the Chameleon with a hole pattern that should match the newer Runcam and Foxeer 3-hole camera cases. The Runcam case still might be a little tight, since it is 0.5mm wider than the Foxeer cases, but you should be able to squeeze it enough to fit. Allows for 15-75deg tilt.
This is the 5 inch Chameleon main plate
Rubber Motor Dampeners, Smooths out motor vibes.
Replacement Lipo Top Plate for Chameleon
These are replacement bolts for the Chameleon frame.
2x M3 8mm cup head iron bolts
2x M3 8mm countersunk iron bolts
4x M3 10mm iron bolts
12x M2 5mm cup head iron bolts
4x M2 12mm cup head iron bolts
Replacement Camera protector for Chameleon
Chameleon Camera Hardware Set
2x rubber dimes
2x alumi thumb screws
2x M2 5mm bolt
2x M2 washer
Armattan Connector Saver
Wrap it or you'll snap it.
Are you are tired of dangling pigtails endangering your props? Are you tired of risking damage to your PDB or battery connector in the event a LiPo ejection in a (spectacular) crash? Try out the Connector Saver to protect you and yours. This clever accessory will allow your c...
Replacement Camera Lever for Chameleon Frame
Available in Orange or Silver